ALCUW glands come with 2 seals, A & B. The table of dimensions (above) gives the range of cable diameters to suit seals A & B. Select the required seal.
Slide the gland nut, then the selected seal over the cable.
Screw the gland body into the enclosure: either by screwing into tapped fitting or inserting through the clearance hole and using Alco locknut. Note: The fibre washer provided is required to maintain the IP66/68 rating. Recommended torque settings are given in the table.
Slide the cable through the gland body until a tail of the required length protrudes through the gland.
Slide the seal into the gland body. Note: A small amount of rubber grease, petroleum jelly or cable pulling lube applied between the outer surface of the seal and the taper of the nut aids assembly.
Slide the gland nut into the gland and screw to tighten, forming a seal.